Popular Search:  Tungsten Electrode  |  Mig Electrodes  |  Welding Rods      中文
Home
About Us
Welding Electrodes
Welding Wires
Core Wire
Welding Accessories
Packing
Service & Support
Contact Us
Products blog link
Welding Electrode Manufacturers
Welding Flux
Cast Iron Electrode
Stainless Steel Electrode
Welding Electrode Suppliers
Copper Electrode
Nickel Welding Electrodes
copper brazing alloys
welding cable
mig welding wires
cast iron welding wire
welding alloys
mig electrode
Cast Iron Welding Electrodes
Home > aluminium welding electrodes > Welding methods
Welding methods
2011-04-21 by seoer

Double-sided spot welding and spot welding is usually divided into two major categories of single-sided spot welding. Double-sided spot welding, the electrode on both sides by the workpiece fed to the welding. A typical two-sided spot welding as shown in Figure 11-5. A chart is the most common way to have electrodes on both sides of the workpiece when the indentation. Figure b said welding area with large plate made of conductive lower electrode, which can eliminate or reduce the following parts of the indentation. Commonly used in the decorative panel spot. The figure for the same c spot welding two or more two-sided spot welding, using a transformer to the electrodes in parallel, this time, the impedance of all current paths to be almost equal, and each  welding wires of the surface state, material thickness, electrodes are subject to the same pressure to ensure that the current through all basically the same spot. D more than the figure for the introduction of double-sided multi-spot welding transformer, so to avoid c deficiency.

Single-sided spot welding, the mig electrode was in the same side of the workpiece feed welding, a typical single-sided spot welding as shown in Figure 11-6, Figure in a single-sided single-spot welding, the electrode is not formed solder joints large diameter and large contact surface to reduce the current density. Figure b is no double-sided shunt little welding, all welding current flows through the welding time zone. Figure C are double-sided shunt little welding, the workpiece above the current flowing through the welding zone without form romantic. In order to provide a low resistance welding current path, in the copper plate underneath the workpiece. Figure d is the distance l when the two large joints, such as frame components and complex plate during welding, in order to avoid undue heating caused by multiple board warpage and reduce resistance between two electrodes, using a special Copper Bridge A, and also pressed on the workpiece electrode.

In mass production, the single multi-spot welding is widely available. At this time can be powered by a transformer, to suppress the rotation of the workpiece electrode pattern (Figure 11-7a), also can be used by each of the separate transformer power supply electrodes, all electrodes simultaneously press and hold the workpiece type (Figure 11-7b). The latter type has more advantages, applications are more widely used. Its advantages are: the transformer can be obtained from the joint placement of electrodes recently, so.

The power and size can significantly decrease; each solder process parameters can be individually adjusted; all joints can welding, production rate; all electrodes simultaneously press and hold the workpiece, can reduce the deformation; more than one power transformer at the same time, to ensure the three-phase load balancing.

   keywords:    aluminium welding electrodes
    nickel alloy welding wire
    mig welding wires
    welding consumables
    welding cable
    welding assembly
    Copper Electrode
    Tungsten Welding Electrode
Copyright 2012-2021 @ Hangzhou Lin'an Dayang Welding Material Co., Ltd. All Right Resrrved          Search engine optimisation and web design by china-webdesign.com