Popular Search:  Tungsten Electrode  |  Mig Electrodes  |  Welding Rods      中文
Home
About Us
Welding Electrodes
Welding Wires
Core Wire
Welding Accessories
Packing
Service & Support
Contact Us
Products blog link
Welding Electrode Manufacturers
Welding Flux
Cast Iron Electrode
Stainless Steel Electrode
Welding Electrode Suppliers
Copper Electrode
Nickel Welding Electrodes
copper brazing alloys
welding cable
mig welding wires
cast iron welding wire
welding alloys
mig electrode
Cast Iron Welding Electrodes
Home > aluminium welding rods > Underwater welding safety measures against electric shock
Underwater welding safety measures against electric shock
2012-09-27 by seoer8



(1) Welding Rod power to DC, disable AC. Because the AC current through the diver's body at the same voltage greater than the DC current. And compared with the DC, AC arc stability, could easily lead to a large splash, and increase the risk of burning the diving apparatus.

(2) All equipment, tools have good insulation and water resistance, insulation resistance shall not be less than 1M. . In order to prevent seawater, the atmospheric salt spray corrosion, need package deposited the reliable watertight insulated jacket, should be well grounded.

(3) welders wear impervious diving suit, wearing the dried rubber gloves, wrapped with a rubber diving helmet the collar metal buttons. Filter hinged on the diving helmet helmet outside, you can open and close, and filter depth should be compared with the land as a pale coloring. Underwater harness all metal parts, the waterproof insulation protection measures should be taken to prevent electrolytic corrosion or spark.

(4) replacement electrodes must issue Lazha signal power to remove the remnants of Aluminium Welding Electroderod head, a new electrode, or the installation of an automatic switch box. Welding rod should be thoroughly insulated and waterproof, only in the form of the end face of the arc to ensure electrical contact.

(5) welders working current Once connected, Never back-ground point of the workpiece, placing themselves between the operating point and the ground point should be facing the ground point, work on their own ground point In between, so as to avoid diving helmet with metal utensils by electrolysis caused damage. The welder avoid the electrode tip to point to their own diving helmet, any time, should pay attention to is not the body or any part of the tool into the circuit.

 

   keywords:    aluminium welding rods
    nickel alloy welding wire
    mig welding wires
    welding consumables
    welding cable
    welding assembly
    Copper Electrode
    Tungsten Welding Electrode
Copyright 2012-2021 @ Hangzhou Lin'an Dayang Welding Material Co., Ltd. All Right Resrrved          Search engine optimisation and web design by china-webdesign.com